product support
sensor mirror round with touch control brightness and 10x magnifier (2020)

simplehuman sensor mirror round with 10x magnifier

product support
sensor mirror round with touch control brightness and 10x magnifier (2020)

troubleshooting

Reset your mirror:
1.Make sure the USB charger and USB charging cable are working. Test them using a mobile phone or a rechargeable product.
2. A full charge will take 4 to 8 hours depending on mirror model and USB charger rating.
3. If the battery level is too low, you may not see any recharge light indication for up to 10 minutes.
4. If the mirror is not able to charge after 4 hours perform mirror reset procedure.

Watch our video on how to reset your mirror.

1. Reset the mirror:
    a. Turn on the mirror by pressing the on/off power button. You should see the recharge light indicator to show green briefly. If it does not, press and hold the on/off power button again.
    b. If you do not see the green light, you need to recharge the mirror.

2. Test the sensor:
    a. Clean the sensor lens using soft cloth.
    b. Place your hand 4-6 inches in front of the sensor to activate the mirror light.

3. Recharge the mirror:
    a. Recharge the mirror for at least 30 minutes and try again.
    b. If the battery level is too low, you may not see any recharge light indication for up to 10 minutes. You can test the sensor again.

Watch our video on how to reset your mirror.

First try this:
1. Clean the sensor with rubbing alcohol and a mircofiber cloth.
2. Make sure there is nothing interfering with the sensor.

If that doesn’t work, reset your unit:
Press the power button on the bottom or the back of the unit (depending on the model) to turn it off. Leave it off for 20 seconds, and then press the power button again to turn the unit on.

First, make sure the mirror isn’t tilted at an angle that is out of the sensor range. You must be within 6-8 inches in front of the sensor (dark-tinted window on the light ring). After a short period of inactivity, light will dim and turn off automatically.

If that doesn't work, recalibrate your mirror:
1. Remove the charger from your mirror.
2. Press and hold the power button on the bottom of the unit for 10 seconds, then release.
3. Wipe the sensor using rubbing alcohol and a microfibre cloth.
4. Make sure nothing is placed in front of the mirror with a minimum 5 feet of clearance.
5. Press and hold the power button again for 10 seconds, then release.
6. Allow the mirror to sit for 1 minute while it finishes the reset.

replacement parts
10x detail mirror, brushed stainless steel

10x detail mirror, brushed stainless steel
PD6169

£15.99
10x detail mirror, rose gold

10x detail mirror, rose gold
PD6219

£15.99
black charger

black charger
PD6095

£14.99
UK 3-pin plug, black

UK 3-pin plug, black
PD6118

£4.99
black USB-C cable

black USB-C cable
PD6263

£9.99
instruction sheet
instruction sheet
Download the instruction sheet for your sensor mirror round with touch control brightness and 10x magnifier (2020).
Download
warranty